Replace Failing Fixtures and Damaged Surfaces

Bathroom Remodeling in Statesboro for leaking tubs, cracked tile, and ventilation failures that cause mold growth

Brown Equity Contractors LLC handles bathroom remodeling for Statesboro homeowners dealing with water damage, outdated plumbing fixtures, or tile that's cracked and letting moisture through to the subfloor. You notice the need when grout lines turn black no matter how often you scrub, the toilet rocks on an uneven floor, or the shower pan feels soft underfoot. This service replaces failing components, updates plumbing and electrical systems, and rebuilds the room to prevent ongoing moisture problems.



Bathroom remodeling involves removing all fixtures, flooring, and wall surfaces down to the studs and subfloor, then rebuilding with proper waterproofing, updated rough plumbing, and materials that handle daily moisture exposure. In Statesboro's humid climate, ventilation becomes critical—exhaust fans must be sized correctly and vented to the exterior, not just into the attic. The work includes installing cement board or other moisture-resistant backer, setting tile with proper slope toward drains, and sealing every penetration to keep water where it belongs.

If your bathroom floor feels spongy near the tub or you see water stains on the ceiling below, contact us to assess what's happening behind the walls and under the floor.

How a Bathroom Remodel Addresses Hidden Damage

You begin by identifying visible problems—cracked tile, persistent mildew, or a shower door that no longer seals—but the real issues often sit behind the walls. Brown Equity Contractors LLC removes fixtures and finishes to inspect framing, check for subfloor rot, and confirm that drain lines slope correctly and vent lines are properly sized. In older Statesboro homes, it's common to find galvanized supply lines that restrict flow, cast iron drains with interior corrosion, or subfloors that were never built to handle standing water.

Once the structure is exposed, damaged framing and subfloor sections are replaced, new plumbing is run, and electrical circuits are added for exhaust fans, lighting, and GFCI-protected outlets. Waterproofing goes on all wet-area walls and floors before tile is set. After the remodel, you'll have a floor that stays dry, grout lines that resist mold, a toilet that sits level and doesn't leak at the base, and an exhaust fan that actually pulls moisture out of the room instead of recirculating it.



The scope varies depending on whether you're replacing a tub with a walk-in shower, relocating fixtures, or simply updating finishes. All plumbing and electrical work is inspected, and waterproofing must meet current standards even if the original installation didn't include it. This isn't decorative—it's about preventing water from migrating into areas where it causes structural damage over time.

Common Questions About Bathroom Remodels

Homeowners in Statesboro often ask about waterproofing, fixture choices, and ventilation during bathroom remodels.

• What happens if the subfloor is rotted? Rotted sections are cut out back to solid material, and new plywood is installed and sealed before any tile or waterproofing goes down.
• How is the shower pan made watertight? A mortar bed is sloped toward the drain, a waterproof membrane is applied over the entire surface, and a second mortar layer goes on top before tile is set.
• Why does the exhaust fan need to vent outside? Venting into the attic traps moisture in the insulation and framing, which leads to mold growth and wood rot over time, especially in Statesboro's humid conditions.
• When should I replace the toilet flange? If the flange is cracked, corroded, or sitting below the finished floor level, it should be replaced to prevent leaks and ensure the toilet seals properly.
• How long before I can use the shower after tile is installed? Grout and sealant need at least 72 hours to cure fully before the shower is exposed to water, or the waterproofing can fail.

Brown Equity Contractors LLC manages each phase of the bathroom remodel, from demolition through final fixture installation and grouting. If you're dealing with soft floors, recurring mold, or fixtures that no longer function correctly, let's walk through what the remodel would involve for your specific situation.